Ada County, Idaho
Sliding Patio Doors in Boise, ID
Idaho's capital, from the historic North End to the Foothills
Boise's homes open to the backyard in every era's style, and a sliding glass patio door is the space-saving way to do it — panels that glide on a track instead of swinging into a room where furniture sits close, on a Bench ranch or a newer Harris Ranch build alike. The reward is a wide sheet of glass that pulls the Foothills view and afternoon light inside. Because a west-facing opening here takes hours of intense summer UV, the low-E, low-SHGC glass package matters as much as the door, and Iron Crest Exteriors specs it to Boise's heat-to-freeze swing. We set the low, wide track dead level so it rolls true, flash the sill against the classic water-entry point, and fit multi-point anti-lift locking and a smooth screen.
What's included
- Space-saving glide operation
- Large glass & views
- Energy-efficient glass packages
- Secure multi-point locking
- Screen & flashing
Across Boise — the North End, the East End, the Bench, and the rest of Ada County — we tailor every sliding patio doors project to the age, style, and exposure of the home.
Our process
How sliding patio doors works in Boise
- 01
Measure & assess
We measure the opening, check the sill, track area, and framing for water damage, and confirm the glass and hardware before quoting.
- 02
Glass & hardware selection
We lay out glass packages, locking hardware, and screen options so the configuration suits your exposure and use before ordering.
- 03
Removal & sill prep
The old slider comes out and we inspect and repair the sill and subfloor, which is where slider water damage commonly hides.
- 04
Set track level & flash
The unit is set dead level so the door rolls true, shimmed, and the sill is flashed and sealed so water drains out and away from the track.
- 05
Rollers, lock & screen
We adjust the rollers for smooth glide, install and test the multi-point and anti-lift locking, and fit the screen.
- 06
Seal & walkthrough
We seal the perimeter, clean up, and walk the glide, lock, and screen with you.
Every Boise job includes pulling any permit Ada County requires and a full clean-up — we leave your home tight, weather-sealed, and looking sharp.
Working in Boise
Idaho's capital, from the historic North End to the Foothills
Boise climbs from the Boise River and its Greenbelt up into the Foothills, layering century-old North End and East End homes over mid-century Bench ranches and newer hillside subdivisions like Harris Ranch. That spread of building eras means the exterior conditions vary block by block — original old-growth wood lap and cedar shakes downtown, painted hardboard and aluminum on the Bench, and 1990s–2000s vinyl on the foothill edges that is now reaching replacement age.
Older Boise homes often hide failing siding and single-pane wood or aluminum windows behind charming facades, while south- and west-facing foothill elevations take a beating from intense afternoon sun. Freeze-thaw swings and wind off the hills make proper flashing, house wrap, and a weather-tight install matter as much as the material itself.
Areas we serve
- the North End
- the East End
- the Bench
- Southeast Boise
- Harris Ranch
- West Boise
Around Boise
- the Boise River
- the Boise Foothills
- the Greenbelt
- Table Rock
Sliding Patio Doors in Boise — FAQs
My older Boise home's patio slider drags and lets in a draft — is it worth replacing?
On a lot of the North End, East End, and Bench homes we see, the original slider was never set level and the rollers and weatherstrip are long gone, so it binds and leaks air. A new unit set dead level on a properly flashed sill rolls with a fingertip and seals tight, and a modern low-E glass package turns a cold, hot-in-summer opening into a comfortable one. We check the sill and subfloor first, since water damage under an old Boise slider track is common and is exactly what we want to find before the new door goes in.
Which parts of Boise do you serve?
All of them — from the North End to the Bench and throughout Ada County. We'll come to your Boise home for a free estimate.
Do you work outside Boise, too?
We do — along with Boise, we regularly handle sliding patio doors in nearby Garden City, Eagle, Meridian, Kuna and across the wider Treasure Valley. If you're near the Boise River, you're well inside our service area.
What's the site like after the work is done in Boise?
Spotless. We finish every Boise project by clearing out old materials and debris, so your Ada County property is left clean and protected.
Why choose a slider over a French patio door?
A slider saves space — the panels glide along a track instead of swinging into the room — and gives a big, uninterrupted glass view, which suits rooms with furniture near the opening. A French door swings for a wider opening and more traditional look but needs clearance. If floor space or view is the priority, the slider usually wins.
Why does my old slider stick and drag?
Usually worn rollers, a bent or dirty track, or a door that was never set level so it binds. We set the new unit dead level and adjust the rollers so it glides smoothly, which is the single biggest factor in a slider lasting.
Sliding Patio Doors in nearby cities
We work across the Treasure Valley near Boise.
Related doors options in Boise
Exterior projects often pair up — here's what goes well with sliding patio doors.
Helpful guides
Plain, local guidance to help you plan your sliding patio doors project.
Need sliding patio doors in Boise?
Tell us about your Boise home and the project you have in mind — we'll come look and give you a straight, free estimate.